Seitenhistorie

Location:

Altensteinstr. 23a, Biolabs 114.XX, 115.XX, 027.1

Responsible Person:

• see OpenIRIS (use and registration see here)

Application/Technical Details

Requirements:

• All users must gain permission to work in the Biolabs and access to the “Zellbio-users” network drive by attending the Biosafety instructions (--> Katharina Achazi)
• All users must get an introduction to the device from the resposnible person (OpenIRIS) before use based on the operation manuals (see below) documented in the device log book
  
• Only use the tubes that are compatible with the rotors we have and follow the tube protocol for filling and operating
• ech run needs to be documented in the device log book
• In case of spillage, open rotor in a sterile bench and clean centrifuge
• DO NOT use organic solvents or other evaporating hazardous substances → use a centrifuge in a chemistry lab instead
• close centrifuge and tube lids during centrifugation
• precisely weigh samples and place them so that the rotor is in balance
• wait after start until centrifuge reaches full speed → if the centrifuge shakes or is noisy stop immediately
• open centrifuge after use and leave lid open, so that no condensed water stay inside and cause corrosion
• clean centrifuge after every use
• be cautious with rotors e.g. during cleaning, exchanging and store them safe
• centrifuges must be cleaned once a month with water and soap and wiped afterwards with 70% ethanol
• centrifuges need to be tested by an authorized service once a year

Instruction/Manual

Serial No.:

FUB Inventory No.:

Safety Operation Instruction (German):